Induction heating system

Products

Compact heater for Trial manufacture and Trial hitting

CX series

  • It is a small inducement heating device with the compound function.
  • It is possible to move to the press neighborhood simply.
  • The trial hitting billet can be heated by the coil exchange and the metal mold can be preheated.
Compact heater for Trial manufacture and Trial hitting CXseries

【 Reference specification 】

Type USH-CX-1UB
Material diameter Φ30~80
Billet length

200mm and less(One piece)

150mm and less(Plurality)

Temperature deviation ±25℃ and less
Heating temperature 1250℃

Outline of CX series

 The heating of the billet for trial hitting and the preheating of forged metal mold are needed as a preparation stage of the forging operation in the hot forging usually.
The energy efficiency was bad because the heating of the billet for trial hitting operated the induction heating apparatus of the main body, and was done the work of the heating of the billet for a small amount of trial hitting by this conventionally, and flexibility was lacked.
Moreover, the temperature management was difficultly holding a lot of difficult points such as time-consuming in the temperature rise by using often the gas burner to preheat the metal mold (It is likely to heat it by putting the heating material on the type in the small one) in this method.

 Therefore, a compact heater for this making for trial purposes and trial hitting is a small inducement heating device with the compound function such as it is possible to move to the press vicinity easily, the trial hitting billet can be heated by the coil exchange, and the metal mold can preheat though was hoped for the practical use of a flash heating possible, small induction heating system to this usage.

Page top

Copyright (C) 2012 Uchino Co.,Ltd. All Rights Reserved.